- Home
- Technical Products
Enterprise Cloud IT Solutions
Test Measurement
Industrial Measurement
- Solutions
Enterprise Cloud IT Solutions
Test Measurement
- Resource Center
- About Us
EN
H3021P Compressed Air Temperature and Humidity Regulator

H3021P
Humidity regulator, thermostat with two relay outputs The T+RH probe is made of hard anodized aluminum and is suitable for compressed air up to 25 bars. It can be used both outdoors and indoors.
Humidity and temperature probes are connected by cables. Measurements can also be converted to other humidity interpretations: dew point temperature, absolute humidity, specific humidity, mixing ratio, specific heat.
The device comes with a T+RH probe with 1 meter cable.
Warranty: 3 years
- Technical Parameters
- Delivery list
Measurement parameters
Temperature
Relative Humidity
Temperature Sensor
Measurement range: -30 to +105 °C
Measurement accuracy: ±0.4 °C
Resolution: 0.1 °C
Humidity Sensor
Measurement range: 0 to 100 % relative humidity
Measurement accuracy: ±2.5 % relative humidity (5 to 95 % at 23 °C)
Resolution: 0.1% Relative Humidity
outdoor spot
Measurement range: -60 to +80 °C
Measurement accuracy: ±1.5 °C at ambient temperature T 30 %.
Resolution: 0.1 °C
Measurement of compressed air humidity
Measuring range: up to 25 bars
Air flow rate: up to 25 m/s at 1 bar (1 m/s at 25 bars)
Relay Output
Quantity: 2
Maximum voltage: 50 V
Maximum current: 2 A
Maximum power: 60 VA
General Technical Data
Operating temperature: -30 to +80 °C
Channel: 1 connectable temperature and humidity probe
Measurements: Dew point, Absolute humidity, Specific humidity, Mixing ratio, Specific heat
Audible alarm: via built-in buzzer - switchable
Battery: 9-30 Vdc
Protection level: IP65 for electronic equipment; IP40 for sensors.
Dimensions: 136 x 159 x 45 mm; external probe length/diameter 88/18 mm
External probe cable length: 1 m
Weight: approx. 400 g
Warranty: 3 years
- H3021P
- Operator's Manual
- Traceable calibration certificate
- Free software for configuring the transmitter TSensor